6 mm Low Profile Pellet Press Die Set Vacuum Die Sets Aluminium release ring with cutout

Aluminium release ring with cutout for viewing pellet during release

When you want to reach a higher density before sintering

All that is required to apply your force to the load cell and you can compare through the load on your hydraulic press guage

The pressure is held for a few minutes

Each Pestle and Mortar are cut and finely ground into shape from a single piece of stone for long lasting durability

6 mm Low Profile Pellet Press Die Set Vacuum Die Sets Aluminium release ring with cutoutThis die set is for a 6 mm (0. 2 inch), short length <6 mm (0. 2 inch) pellets. The compact design and high strength heat treated stainless steel means a higher force can be applied while pressing reducing the chance of plunger breakages. Features of this die set are: Compact Design: Built for High Loads High Strength Stainless Steel: Heat treated to 160,000 psi Built in ejector sleeve Heatable up to 250C (482F) Low profile pellet press die sets