Throw Lever for Gen 2 Vortex Strike Eagle 1-6 1-8 LPVO To remove the cover

To remove the cover

This is a 3D printed protective housing for the EOTech G43 magnifier (see my other listings for G33 and G45)

The dye (and anodizing) alter a small depth of material on the surface but deep scratches will reveal the bare material underneath

small defects may be present

I will include some sample material that you can use to test your dye mix before dying the magwell

Throw Lever for Gen 2 Vortex Strike Eagle 1-6 1-8 LPVO To remove the coverThis is a 3D printed throw lever for the Gen 2 Vortex Strike Eagle 1 8 and 1 6 LVPO. If you are not sure if this will fit, message me with a photo of your optic for verification. The material is a carbon reinforced nylon, which means it is tough and can handle high temperatures without warping (250+ deg F). A short overview of the lever can be seen here: https: youtu. be Nx2VyTgG2 8 This listing is for the throw lever and mounting screw only. You will